SANS's 2026 State of ICS/OT Security survey, published this week, reports that 34% of industrial respondents had an ICS/OT cyber incident in the past year and that 72% of those incidents caused downtime. The clearest message for OT operators is that recovery confidence is often untested: rehearse manual operations, fold OT into continuity planning, and map your dependence on key people and vendors.
What happened
On 10 November 2026, SANS released insights from its 2026 State of ICS/OT Security survey, written by SANS principal instructor Jason Christopher. Help Net Security reported on 12 November that the survey drew 696 practitioner responses, and IndexBox and Techitup Middle East published summaries the same day. The figures below are as those outlets report them; they are self-reported survey answers, not measured outcomes.
According to Help Net Security, 34% of respondents had an ICS/OT cyber incident in the previous 12 months, which it describes as 1.7 times the 2025 rate and the largest single-year rise SANS has recorded. Of those incidents, 72% led to facility or system downtime. Only 41% of incidents were detected within 24 hours, down from more than half in 2024 and 2025.
IndexBox, citing the SANS findings, reports that compromise of shared IT/OT credentials and identities matched ransomware as the most common incident type, each at 31%. Respondents reporting an incident with a safety impact rose from 8% to 13%, and only 13% said they have full IT/OT visibility across the attack chain. Dedicated ICS/OT detection platforms found 38% of reported incidents, more than any other method, yet 43% named budget as the main barrier to expanding them.
The most striking finding is a gap in confidence. Help Net Security reports that 38% of security leaders expect to keep running indefinitely on islanded ICS/OT systems after an attack, and the remaining 62% expect to manage temporarily on manual controls. Among practitioners, however, only 15% said critical processes could run safely in manual mode for more than 48 hours, while 40% did not know. In the report, Christopher writes that "an untested assumption is not a capability".
Dependencies also feature heavily. 68% of respondents said losing one or two experienced staff would delay response or create serious operational risk, and 58% said they would be unable to operate within a year if their main automation vendor disappeared. According to IndexBox, only 20% report a fully functioning supply chain cyber risk programme.
There is a positive signal. Organisations that test plans at least annually and fully integrate ICS/OT into business continuity and disaster recovery (BC/DR) were more confident: 46% of that group expected to restore their most critical facility within a day, against 27% of all respondents. Only 16% have fully integrated BC/DR, and 29% test annually.
Why it matters for OT
For industrial operators the question after an incident is rarely whether data was lost. It is whether the process can keep running safely, and for how long. The survey suggests many organisations have not tested that answer. A plan that assumes operators can switch to manual control is only as good as the last time those operators actually did it, with the right procedures, local instruments and staffing.
The rise in shared credential compromise also matters. Where engineering accounts, jump hosts or remote access gateways share identity stores with corporate IT, an IT compromise can become an OT problem quickly. Combined with slower detection and limited visibility, this gives attackers more time in flat or poorly segmented networks before anyone notices.
Finally, reliance on a small number of experienced engineers and a single automation vendor is a familiar feature of legacy OT. It is not a failing in itself, but it is a risk that should be documented and planned for rather than discovered during an outage.
Who should act
The findings are relevant to every sector the survey covered, including energy and utilities, oil and gas, chemicals, manufacturing, water and transport. Operators preparing for NIS2 in the EU, the NCSC Cyber Assessment Framework in the UK or NCA OTCC in Saudi Arabia can use these questions as a practical check on their continuity and incident planning. Leaders who answered confidently about indefinite operation should compare that view with what their plant teams say.
What to do now
- Ask the plant, not just the board. Run a short survey or workshop with operators and control engineers: how long can each critical process run safely without SCADA or DCS, and what would they need to do it?
- Rehearse manual operation. Include operators, plant managers and the ICS/OT security team in at least one tabletop or practical exercise a year, using realistic scenarios such as loss of the HMI layer or a ransomware outage on site servers. Our notes on OT incident readiness cover how to scope this safely.
- Fold OT into BC/DR. Make sure continuity and disaster recovery plans list OT systems, recovery order, offline backups of PLC and HMI projects, and who can restore them. Test at least one restore of an engineering workstation or controller configuration.
- Separate IT and OT identities. Review where OT access relies on corporate directory accounts, shared passwords or common jump hosts. Use dedicated OT accounts, multi-factor authentication for remote access, and log privileged sessions.
- Improve what you can see. Start from an accurate OT asset inventory and passive network monitoring at key conduits, so incidents are detected in hours rather than days.
- Map people and vendor dependencies. Record which individuals and suppliers each critical system depends on, document their knowledge, and agree support and escrow arrangements where possible. Treat these as entries in your OT risk management process, with owners and review dates.
How OTVista helps
OTVista researchers study how industrial organisations can test resilience assumptions without disrupting operations. Our OT cybersecurity assessment and risk assessment services review recovery plans, identity separation and dependencies against your operational reality. You can also start with the free OT security self-check to see where your programme stands.
Sources: Help Net Security, CISOs say OT will survive a cyberattack, but their engineers aren't so sure; IndexBox, SANS 2026 ICS/OT Security Survey: 34% Hit by Cyber Incidents, 72% Disrupted; Techitup Middle East, SANS Releases 2026 State of ICS/OT Security Survey; Viakoo via Security Boulevard, Daily OT Security News: November 11, 2026
Cover photo: Tasha Kostyuk on Unsplash, used under the Unsplash License.
Topics: SANS 2026 ICS/OT survey, OT incident response, OT cyber resilience, manual mode operations, OT business continuity, ICS security survey
